I am a total newbie to anything RC and this is my first attempt at this hobby. The whole Tx menu and settings are alien to me. After watching many videos and trying to grasp the manual with my F450 DJI Wookong M, I finally hooked up everything. I am totally stuck on why my motors are not turning when I do the Combination Stick Commands. Please see my photos and the Transmitters and receivers I am using. I have a feeling its the Turnigy stock receivers or I do not know how to setup the Tx Short Video: http://youtu.be/0IV66KvymEQ Attempt #1 Turnigy 9x Tx modded to er9x firmware in HELI mode Turnigy 9X8C v2 Receiver Calibration is out of wack, Elevator doesnt go all the way in one direction. Had an RC airplane friend look at Tx but he couldn't figure it out either. Attempt #2Turnigy 9x Tx (I have 2 Txs, this one is stock) in ACRO mode Turnigy 9X8C v2 Receiver Calibration seemed to go well, but the Combination Stick Commands did not move the motors. Future Attempt #3 Turnigy 9x - er9x firmware FrSky D8R-II 2.4ghx ACCST Telemetry Receiver Results coming in a couple of days..... DJI WOOKONG LED LIGHTS - 3 red and 1 blue flash (at one point it had a green solid light, but it never happened after that, don't know what I did to get a green solid light) DJI SOFTWARE - All I have really done is clicked on Quad-rotor X, and the Tx Calibrations to see if the Tx is binded and working and then I clicked on Write, software didnt give any indication it was writing or was done with writing. If anyone can help me via skype or something that would be appreciated, I've checked every imaginable youtube video out there and I can't seem to find the problem. Have I wired up something wrong? Feel free to ask for anymore videos or photos.