Regarding the OPTO ESC anD DJI

Discussion in 'DJI General Discussions Forum' started by john420, Dec 6, 2013.

  1. john420

    john420 New Member

    Joined:
    Aug 10, 2012
    Messages:
    98
    Hi Does one have to cut the red wire of the Opto ESC when he connecting it to DJI WKM or it is only for non OPTO ESC since i made a WKM and in DJI manual says if u use non Dji ESC u have to cut the wire I am using RCTimer ESC 40a
    Thanks
     
  2. TheUFGadget

    TheUFGadget New Member

    Joined:
    Apr 3, 2013
    Messages:
    136
    If it is an opto of any brand then you do NOT have to cut the wire. If the ESC has an internal BEC then you should just remove the middle pin and heat shrink it instead of cutting it so that you can reuse on another project if you upgrade :)
     

Share This Page